Hei.
Jeg definerer x:=5,4..10 i mathcad. Hvordan reseter jeg x tilbake til en variabel igjen?
Vennlig hilsen
Gøran
Mathcad problem
Moderatorer: Vektormannen, espen180, Aleks855, Solar Plexsus, Gustav, Nebuchadnezzar, Janhaa
Uten noen spesifikke kunnskaper i området, tipper jeg det du trenger å gjøre er følgende:gran_johansen skrev:Hei.
Jeg definerer x:=5,4..10 i mathcad. Hvordan reseter jeg x tilbake til en variabel igjen?
Vennlig hilsen
Gøran
x=x
Da vil x logisk sett være x.
fiasco
Googla saken:
To reset variables for further calculation, use the assume function
as follows: assume variablename
This will allow you to use variablename as an unknown, but only if you
perform symbolic calculations.
Fra:
http://64.233.183.104/search?q=cache:9T ... =firefox-a
To reset variables for further calculation, use the assume function
as follows: assume variablename
This will allow you to use variablename as an unknown, but only if you
perform symbolic calculations.
Fra:
http://64.233.183.104/search?q=cache:9T ... =firefox-a
fiasco